 |
|
|
|
Wall Jacks - Instructions
previous | 1 2 3 4 | next
|
|
|
| Caution |
Warnings for Proctor Wall Jacks.
|
|
|
|
CAUTION Read and understand Operating Instructions for Proctor Wall Jacks. Examine specific local, state, and federal regulations, including American National Standards Institute and OSHA regulations, which may apply to your use of this product before putting to use.
WARNING Do not use this product if any parts are missing, bent, frayed, out of alignment, or damaged. If there is any concern that the product is not in good working condition, contact your dealer or Proctor Products Company.
WATCH YOUR TACKLE Insure that your Proctor Wall Jacks have sufficient capacity and safety margin to handle your required load. Do not allow cable to contact sharp edges or make sharp bends which will damage cable. Stand clear of loads and lines. Never occupy a space under a load of any kind.
WARNING Do not overload! The weight and wall height capacities of your Wall Jacks are stated in your instruction packets and on the product labels on the lower tube.
CAUTION Always maintain three or more wraps of cable on the winch drum, and insure that the cable is secured to the drum with the set screw.
REPAIR Insure that all parts are in place, in good condition, and working properly before each use. Replace worn, damaged, or missing parts with genuine replacement parts from your dealer or Proctor Products Company.
LUBRICATION Keep bearings and moving parts properly lubricated for longer life and easier operation.
CONVERSION Hand winches converted to power operation become the sole responsibility of the user. Such conversion voids any warranty or liability obligation on the part of Proctor Products Company.
WARNING All people working with or near Proctor Wall Jacks, or assisting in hooking or arranging a load, should be instructed to keep out from under load at all times. From a safety standpoint one factor is paramount: Conduct all lifting operations in such a manner that if there is an equipment failure no person would be injured. This means keep out from under raised load, keep out of the line of force of any load, and keep the area clear on the far side of the wall being raised.
WARNING It is the owner's and user's responsibility to determine the suitability of this product for their particular use. Check all applicable industry and trade association standards, and federal, state, and local regulations. Follow the Operating Instructions and head the Warnings.
WARNING Do not use this product to lift or lower persons, and never lift or lower loads over persons.
|
previous | 1 2 3 4 | next
|
|
